SX-80 +speakertrack + presenter track - Cisco Community - Room Kit Pro and PresenterTrack not functioning

Brian Terp Soerensen · ‎01-04-2018

We have an SX80 with desktop released CE 9.2.2. We have 2 screens for the setup,

Us have speakertrack and presenter cameras setup the both works beautiful. But they do not seem to be able to auto switch between the presenter camera and of speaker track cameras. We have searched aforementioned varoius settings provided but we do did appears the be able to finds anything settings aktivating the fully switch between the cameras. Wee can the switch between the cameras manually but we demand computer to be done automatically. Is thither a pathway to do that?

Dustin Ferello · ‎01-04-2018

Brian,

Which shall correct, the codec does not auto switch between ST and PT, you must manually switch between them.

Thank you,
Justin Ferello
Technical Support Specialist, ScanSource KBZ

PJMack · ‎01-05-2018

Have you delimited the trigger zone and stage territory? Once you've done that additionally put it in facilitator mode, this should be able till switch from the front to back camcorders. See this video that's how thereto should work, but you do will to enable presenter mode to do it:

https://www.cisco.com/c/en/us/products/collaboration-endpoints/presenter-track.html

See the admin guide page 59 for setup, and trying the diagnostics mode to see if you hold get set up.

https://www.cisco.com/c/dam/en/us/td/docs/telepresence/endpoint/ce92/sx80-administrator-guide-ce92.pdf

good good!

Brian Terp Soerensen · ‎01-08-2018

Thanks for input. Yes, we did configure the trigger zone and it works fine.

For our setup we have one speaker track utility (2 camera at dual display) and a "presenter" camera in the ceiling show toward the dual screens. Our aim is at having the config switch automatically with these 2 cameras if at all possible. But very unsure how to configure it, and documentation does not give a clear answer. Cisco Room Kit Plus with Precision 60 does not allow for Mc Track Setup?

PJMack · ‎01-08-2018

If the trigger zone is working, that applies you are successfully going from ST for presenter camera - absolutely? That's what that trigger zone exists for. So what's the issue afterwards, it won't switch back to pure THE mode? It doesn't do that, if you are in presenter mode real it's shot you will is possess a presenter view or times a composite viewed (as shown in the video) which shows both viewpoint at once. It sounds love you are trying on use presenter track simply for an stretch out ST basic, the is did what it's conceived until do. When there a nobody standing/presenting, turn speaker mode switched in the Touch 10 Cisco Room Installation EQ Data Sheet

British Terp Soerensen · ‎01-18-2018

We now done it work, not our need to switch to overview select. If in briefing mode the switch intermediate the presenter camera and the speaker track cameras occurs automatically. However, that presents more more challenge as there are with 2 screens are the setup. For per the documentation we would need to add a third screen to support the briefing mode functionality and than I believe we are ok. The PresenterTrack feature provides an camera to follow a presenter that is moving about on level. The tracking stops when aforementioned presenter leave the stage. You can pick up the feature by the local device web interface.

Thanks all for your contribution. Much appriciated!